| Component |
Type |
Excerpt from Data Sheet |
Download |
| Si9976DY N-Channel Half-Bridge Driver |
transistor cross reference |
Cross-Conduction Protection The high-side power transistor can onlylow-side power transistor. Pin 10: GND The ground return for V+ logic reference |
 |
| TISP83121D DUAL-GATE UNIDIRECTIONAL OVERVOLTAGE PROTECTOR |
transistor cross reference |
TRANSISTOR BUFFERS -VE REFERENCE VOLTAGE +VE REFERENCE VOLTAGE 0 AI8XAB +V BAT -V BAT (B) K A G1 TISP83121D G2 -VE REFERENCE VOLTAGE +VE REFERENCE VOLTAGE |
|
| Control circuit for a Self-Oscillating Power Supply (SOPS) |
transistor cross reference |
output cross-referenced in the following descriptionRIO 1 regulation indicator output LED 2 LED driver output I ref 3 current reference setting T on(min) 4 transistor |
|
| RF2516 |
transistor cross reference |
pin is connected directly to the reference oscillator transistor base. The intended referencecross-coupled to provide positive feed- back and a 360° phase shift |
|
| Off-line SMPS Controller with 600 V Sense CoolMOS on Board TDA16831-4 R ? T |
transistor cross reference |
the current through the MOS transistor is compared with a referencereference signal pwmin. Pwmin is created by an external optocoupler or external transistor and |
|
| KA2811C 12V Spindle Motor and Voice Coil Motor Driver |
transistor cross reference |
transistor base 43 SINKA2 O External NPN transistor base 44 SOURCEA O External PNP transistor base 45 SINKA1 I External NPN-PNP transistor base 46 CLOCK I Reference |
|
| KA2811C 12V Spindle Motor and Voice Coil Motor Driver |
transistor cross reference |
transistor base 43 SINKA2 O External NPN transistor base 44 SOURCEA O External PNP transistor base 45 SINKA1 I External NPN-PNP transistor base 46 CLOCK I Reference |
|
| Bourns Circuit Protection |
transistor cross reference |
the transistorcrowbars. Under low level power cross conditions the TISP83121D gate current will charge the gate reference supply. If the reference supply |
|
| IMVP Mobile Power Supply Controller |
transistor cross reference |
external NPN bipolar power transistorControl Circuit Prevents CrossEXT) D 32-Pin TSSOP PowerPAD ™Enhances Thermal Performance D 1% Reference |
|
| 786- x 488-PIXEL CCD IMAGE SENSOR |
transistor cross reference |
the gate of MOS transistorshow cross sections with potential-well diagramsan internal voltage-reference generator that provides the reference |
|
| "735- X 580-Pixel CCD Image Sensor" |
transistor cross reference |
the gate of MOS transistorand image-storage areas Crossan internal voltage-reference generator that provides the reference bias for the reset and clamp |
|
| SANYO Electric Co.,Ltd. Semiconductor Bussiness Headquarters |
transistor cross reference |
such as transistor, is used for antenna damping, cross modulation which occurs when the transistorBUF 320 380 mVrms LA1135, 1135M No. 1272-2/18 Page 3 Reference |
|
| KA3121 Spindle Voice Coil Motor One Chip Driver |
transistor cross reference |
SUBGND -VCM power transistorVDD CRET2 SUBGND PCS W V U PVCC CBRAKE BRAKE N GND ADJ VREF CDLY SENSE12 SENSE5 Power on reset Bandgap Reference &Bias Zero cross |
|
| LXT6155 |
transistor cross reference |
TTL =Transistor-to-Transistor Logic (5V tolerantreference. If CIS =High, then the LXT6155 uses the crystal clock input (XTALIN) as the reference. 15 |
|
| DATA SHEET |
transistor cross reference |
voltage surges. The transistoramplifiers in a single package •Superior cross1 Simplified outline and symbol. Marking code: L2- QUICK REFERENCE |
|
| LC75347E |
transistor cross reference |
transistor open-drain outputs. Featurescross: Provides independent zero-crossgeneration from internal switches. Built-in analog ground reference |
|
| BRUSHLESS DC MOTOR DRIVE ACT5101-1 HIGH VOLTAGE 3-PHASE |
transistor cross reference |
is a composite of a transistor with an N-channel MOSFET connected to the base of a PNP transistorstage from accidental crossT J of +150°C. Reference |
|
| Power-Factor Controller (PFC) TDA 4862 IC for High Power Factor and Active Harmo.. |
transistor cross reference |
output transistor and one in series with the sink output transistor, reduces the crossoperation mode •High current totem pole gate driver •Trimmed ±1.4% internal reference |
|
| INTEGRATED RINGING SLIC FOR SHORT LOOP APPLICATIONS |
transistor cross reference |
Driver of the external transistorand power-cross32 IREF Voltage reference output to generate internal reference current. 33 CREV Reverse polarity |
|
| Side-Airbag Sensor Dual Interface |
transistor cross reference |
With high immunity against crossreference pin 2 RETURN1 Return line of the external unit, internally connected to GND via a line-protection transistor 3 OUT1 Voltage |
|
